Skip to content

Lead statuses

A status is a label about the lead itself — New, Qualified, Junk, Not interested. One lead has one status at a time.

A status is not a stage. A stage is where the lead is in your process; a status is what you have concluded about it. If you only need one of the two, use stages.

Before you start

  • You need the tenant.settings.manage permission.

Steps

  1. Go to Settings → Lead statuses.
  2. Add a status, or rename an existing one.
  3. Mark one as the default — every new lead starts there.
  4. Save.

What this affects elsewhere

  • The status picker on every lead, and on the post-call form.
  • Automation can trigger on a status change and can set a status.
  • Reports that break leads down by status.

What you cannot change later

Statuses are retired, not deleted. Switching one off removes it from the pickers and leaves it readable on every lead that already has it. A lead whose status was "Junk" two months ago still says so.

The default cannot be retired. New leads would have nowhere to land. Make another status the default first, then retire this one.

If it does not work

What you see What it means What to do
"A retired status cannot be the default" You tried to default a switched-off status Switch it back on first
The default will not retire New leads need somewhere to land Set another default first
A retired status still shows on old leads Expected Retired means out of the pickers, not erased

Last checked against the product on 2026-10-10. Needs the tenant.settings.manage permission.